Hi guys,
I am a software engineer, trying to do some electronics hooby work.
I am trying to build a controller circuit with Teensy 4.1 board and trying to design a professional looking PCB for the project.
My circuit design is very simple, I want to connect most of the Teensy 4.1 pin to a 40 pin strip header connector.
From there I can connect other components (I.e. switched and potntiometers). the design dilemma I am having while trying to drawing the schemetic for this iny project is, how to connect the ground of the teensy board to all the sswitches?
all the switched and potentiometer get connected to a common ground pin, but I am not sure how to make this connection cleaner?
What is the best way to desing these kind of common ground connction, where the ground is shared with 30+ seperate components?
I am doing the drawing usinf EasyEDA.
Thanks,
M
I am a software engineer, trying to do some electronics hooby work.
I am trying to build a controller circuit with Teensy 4.1 board and trying to design a professional looking PCB for the project.
My circuit design is very simple, I want to connect most of the Teensy 4.1 pin to a 40 pin strip header connector.
From there I can connect other components (I.e. switched and potntiometers). the design dilemma I am having while trying to drawing the schemetic for this iny project is, how to connect the ground of the teensy board to all the sswitches?
all the switched and potentiometer get connected to a common ground pin, but I am not sure how to make this connection cleaner?
What is the best way to desing these kind of common ground connction, where the ground is shared with 30+ seperate components?
I am doing the drawing usinf EasyEDA.
Thanks,
M