This used to work quite well. Instead of the MCP1403 driver, I had a Clare 1035 relay to trigger the P type MOSFET with a PIC. Now I try a MDP1403 connected like the attached schematic and the drivers overheat and fail.
I thought maybe I was overworking the MOSFET so I soldered another one on top of the first driver, same result.
Spec sheets on the MOSFET and driver are attached.
Any ideas?
Thanks in advance
Toby
I thought maybe I was overworking the MOSFET so I soldered another one on top of the first driver, same result.
Spec sheets on the MOSFET and driver are attached.
Any ideas?
Thanks in advance
Toby
Attachments
-
809.3 KB Views: 26
-
111.7 KB Views: 15
-
13.7 KB Views: 22