Hi,
I have developed a small system that fit in a box and I would like your advice on what should be done in order to protect my electronics a bit as I am not an expert and I feel like my system is very exposed now.
so far the architecture is like this:
---------------Custom Box-----------------24VDC Sensors
------- being the cables
In my box, I have a PCB driving the 24VDC to my sensors, and a step-down regulator to give 5V to a Single board computer (raspberry pi zero like). the step down regulator used is this one:
Should I also include some kind of over current or overvoltage protection in my box? what would be the easiest way to implement it? I can include it in my PCB if needed.
Thank's for your help,
Tibibs
I have developed a small system that fit in a box and I would like your advice on what should be done in order to protect my electronics a bit as I am not an expert and I feel like my system is very exposed now.
so far the architecture is like this:
---------------Custom Box-----------------24VDC Sensors
------- being the cables
In my box, I have a PCB driving the 24VDC to my sensors, and a step-down regulator to give 5V to a Single board computer (raspberry pi zero like). the step down regulator used is this one:
Should I also include some kind of over current or overvoltage protection in my box? what would be the easiest way to implement it? I can include it in my PCB if needed.
Thank's for your help,
Tibibs
Last edited by a moderator: