hello again!
I am trying to make an object avoiding robot without micro controller. below is the link from where i am taking help.
http://www.engineersgarage.com/contribution/obstacle-avoiding-robot-without-microcontroller?page=1
I am right now designing 555 timer control (part of object). From circuit, 555 timer is being used in astable mode.
But how exactly is it working?
because in astable, it will give continuous output.
In my opinion 555 timer should be used in mono-stable.
is my opinion correct, if not then why?
image from site of 555 timer is also attached. (pin 2 is connected with pin 6, written on site).
I am trying to make an object avoiding robot without micro controller. below is the link from where i am taking help.
http://www.engineersgarage.com/contribution/obstacle-avoiding-robot-without-microcontroller?page=1
I am right now designing 555 timer control (part of object). From circuit, 555 timer is being used in astable mode.
But how exactly is it working?
because in astable, it will give continuous output.
In my opinion 555 timer should be used in mono-stable.
is my opinion correct, if not then why?
image from site of 555 timer is also attached. (pin 2 is connected with pin 6, written on site).
Attachments
-
240.9 KB Views: 12