Ni Evlis 2+ prototype board help with hooking up transformer.

Discussion in 'Digital Circuit Design' started by Ashley1nOnly95, Feb 7, 2017.

  1. Ashley1nOnly95

    Thread Starter New Member

    Feb 7, 2017
    11
    0
    I'm doing a circuits lab and I have reach a part in the lab that I can't seem to figure out. I am supposed to use a 6.3 vac transformer which I am supposed to hook up to my high pass filter setup. The problem is I don't know how to create the 6.3 vac transformer. I also need help figuring out where to put the second line of the transformer. Right now I have it hooked up to ground but I feel that isn't right.


    On the picture I have it hooked into the function generator.

    The lines that are connected at the top are going to the oscilloscope on channel 0 and channel 1. Channel 0 shows me the original wave and channel wave shows me the changed wave.
     
Loading...