Hello again everyone,
I am hoping to build an LED panel for use in photography. As such, I need to be able to control the brightness of both colours of LED chips on the strip.
I'm looking at the following LED strip.
The "claimed" specs are:
Now, I know (roughly) how to build a voltage-dimming circuit for a SINGLE colour led strip, based around amazon-available voltage regulating boost converters. However, the dual-colour nature of this setup is throwing me off, because I don't know how to set up a potentiometer to gradually shift the delivery of power from one led colour to the other.
I have an understanding of basic circuits and terminology, but I am no electrical engineer, so
Thanks in advance for any help!
-Ty
I am hoping to build an LED panel for use in photography. As such, I need to be able to control the brightness of both colours of LED chips on the strip.
I'm looking at the following LED strip.
The "claimed" specs are:
- Voltage: 24V DC
- Current: 4A/roll (@ 600 LEDs per roll = 6.6 mA per 5050 LED??)
- Power: 96W /roll
Now, I know (roughly) how to build a voltage-dimming circuit for a SINGLE colour led strip, based around amazon-available voltage regulating boost converters. However, the dual-colour nature of this setup is throwing me off, because I don't know how to set up a potentiometer to gradually shift the delivery of power from one led colour to the other.
I have an understanding of basic circuits and terminology, but I am no electrical engineer, so
Thanks in advance for any help!
-Ty