All About Circuits

Need a little help identifying these two components - Photo

Sinus23

Sinus23

Joined Sep 7, 2013
248
Lumenosity said:
Why would the people who put the board together use resistors that did not match what was printed on the PCB? Maybe the boards were all printed but it was later discovered that 3.6k resistors worked better?
Click to expand...
Quite possible an afterthought found out in later testing.

Are you sure that the unit you have is 12V to 5V? (without some tweaking)
 
Lumenosity

Thread Starter

Lumenosity

Joined Mar 1, 2017
614
Sinus23 said:
Quite possible an afterthought found out in later testing.

Are you sure that the unit you have is 12V to 5V? (without some tweaking)
Click to expand...
100%
It is a car cigarette lighter multiplier where you plug a dongle into the existing cigarette lighter outlet and it powers 3 plus has a USB outlet.
 
Lumenosity

Thread Starter

Lumenosity

Joined Mar 1, 2017
614
I can't see how Pin 6 gets Vcc IN ?
Maybe that's why the USB port never worked?
Can you see how it would from the schematic?

USB_Tiger_schema.jpg
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
G Single cylinder Arduino CDI code works, but does need a little tweeking. Can you help please? Programming & Languages 0
T Need a little help with variable resistor Technical Repair 3
P Need help in making my own little experiment in EdSim51 Homework Help 3
S Need a little help building my first circuit without a breadboard. General Electronics Chat 22
O Need little help with an old Switchable PSU Power Electronics 10
Similar threads
Single cylinder Arduino CDI code works, but does need a little tweeking. Can you help please?
Need a little help with variable resistor
Need help in making my own little experiment in EdSim51
Need a little help building my first circuit without a breadboard.
Need little help with an old Switchable PSU

You May Also Like

Top