Above is the thread starter.
From now on this thread will be updated as this project progresses
Hi BMorse
I am posting the pictures without finding their capacity as per your request, and since my buddy is back and I got the cam, I thought I'll start by posting the pics of all the motors I have.As per forum member request I will be making this engraver via this thread and every one please feel free to comment.
As BMorse requested here are the pictures of the motors that I currently have.
This is the dremmel that I use for now. I will post the specs separately.
This is a DC motor and runs around 48V I think, I did tried it once using 24VDC. It has plenty of torque and RPM. I have to measure the RPM later.
Above is the motor that I was talking about, the lazer disc drive motors, it has a high rpm and runs on around 24VDC. I remember this having a good torque. I have to recheck, if you like.
This one was salvaged from a xerox machine. Haven't tried to run it yet.
This is also a DC motor, could not check it since a bloody rat has chewed of the cables all the way. I have to dismantle and rewire it.
These are as you know printer steppers.