Mc-2100 Tread mill controller question .

Thread Starter

animal12

Joined Feb 20, 2018
46
I know theres some folks that know a bunch about these treadmill motor controllers . As far as you folks have seen are HD2 pinouts the same on all MC-2100s ?
left to right
black
violet
yellow
orange
blue
green
red
thanks
animal12
 

Thread Starter

animal12

Joined Feb 20, 2018
46
Thanks , thats what I was thinkin , I keep thinking that I read somewhere that they had a board that had something different as far as the pin orientation .
thanks much
animal12
 

Thread Starter

animal12

Joined Feb 20, 2018
46
Thanks , thats what I was thinkin , I keep thinking that I read somewhere that they had a board that had something different as far as the pin orientation .
thanks much
animal12
If ya look at the schematic that comes with the treadmills with MC2100's everyone that I have seen with a MC2100 shows the pin-outs backwards on HD3 Opposite of what I showed in post #1
animal
 

Thread Starter

animal12

Joined Feb 20, 2018
46
oK I screwed up on the HD # . Let me rephrase
If ya look at the schematic that comes with the treadmills with MC2100's everyone that I have seen with a MC2100 shows the pin-outs backwards on HD2 Opposite of what I showed in post #1 ?
thanks
animal12
 
Top