All About Circuits

Low Power Class AB Amplifier

Search Forums New Posts
Audioguru again

Audioguru again

Joined Oct 21, 2019
6,826
RRRRSSSS said:
In your post #15 you had a 0.5 volt input signal and a peak output voltage of 4.0. My circuit is
identical as far as I can see.
Click to expand...
I increased the input signal level to show you that I biased the circuit for symmetrical clipping for a maximum output level.
You biased your previous circuit wrong with unsymmetrical clipping (the bottom of your output waveform was clipping) resulting in a low power output without any clipping.
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
S Class A Power Amplifier Analog & Mixed-Signal Design 8
M Low Power Class AB Amplifier PCB Layout , EDA & Simulations 53
_nisha246_ designing a class E power amplifier operating at 900MHz in ADS. Wireless & RF Design 3
R Low Power Class AB Amplifier Analog & Mixed-Signal Design 82
Y Repairing a power supply of a Class-D amplifier Technical Repair 3
Similar threads
Class A Power Amplifier
Low Power Class AB Amplifier
designing a class E power amplifier operating at 900MHz in ADS.
Low Power Class AB Amplifier
Repairing a power supply of a Class-D amplifier

You May Also Like

Top