Hi all,

I'm new here so please forgive if this is not appropriate for this particular forum.

I'm looking for a specific connector, as shown in the attached picture.

Anyone has any idea where I could look for this?

Also if anyone knows of specific places to look for specific connectors it would be greatly appreciated if you could share.

Thanks!

 

Search on Digikey site, they supply many manuf connectors.

 

Welcome to AAC!

I'm looking for a specific connector, as shown in the attached picture.

Looks like 0.093" molex to me.

From Jameco's 2017 catalog:

 

Welcome to AAC!
Looks like 0.093" molex to me.

From Jameco's 2017 catalog:
View attachment 291929

That does look very similar.
Nice identification, didn't expect such a quick response
Thanks very much, I'll check.

 

Nice identification, didn't expect such a quick response

Sometimes you get lucky.

 

Sometimes you get lucky.

I have another connector I'm looking for. Maybe you would recognize that one also by chance?

 

Look up TE Mate-N-lok I believe I have got them from Digikey in the past.

 

Look up TE Mate-N-lok I believe I have got them from Digikey in the past.

Thanks for responding!
I have not been able to find it there, but I did find this:

https://www.digikey.com/en/products...EDgP5qXEqdATK194lWmzLj2odqJyvhzRoCtK8QAvD_BwE

I feel like I'm missing the language to properly describe these connectors when looking for them.

3 pin is all I really know.
I don't know what dimension is the key to these products. For example, this link says that the connector is 0.165". What is that length in the connector?
The data sheet says pitch, I'm not sure what it refers to. But let's say I wanted to search the internet by myself with specifications taken from a connector that I am holding, I don't know what I could use other than the number of pins.

 

I found this as the... Male? Female? In this case I'm not sure, it doesn't say.

https://www.digikey.com/en/products/detail/molex/0039014037/2405387

But it looks the same as the counter part I have.
I guess I'll get a caliper and compare dimensions from the data sheets to what I have in hand.