LNK306 - Expecting 5.0V output... getting 10.4V output instead

Status
Not open for further replies.

Thread Starter

Mahonroy

Joined Oct 21, 2014
406
Hey guys,

I used the LNK306 to create a 5.0V rail on my PCB. (120VAC input). I used the datasheet to come up with the component values.

The problem is that I am getting a 10.4V output instead of the desired 5.0V. I double checked the feedback resistors, and they are 2K and 3.84K which should generate the desired 5.0V output.

Has anyone had any experience with these line of IC's? I attached my circuit schematic, and the PCB layout of the circuit. Any help would be greatly appreciated as I am at a loss as to what might be wrong, or how to go about finding the problem, thanks!

Here are the part #'s I am using for the Inductors, Diodes, and Capacitors:

D1, D3: DFLU1400-7

D2: US1JHE3/61T

D4: FM4007W-W

L1, L2: 46105C

C4: GRM219R61E106KA12D

C6, C7: 475CKE450MLN

C8: 35ZLH100MEFC6.3X11

R3: WP2S-7R5JA25

lnk306_problem1.jpg
lnk306_problem2.jpg
 

Dodgydave

Joined Jun 22, 2012
11,285
Can only suggest altering the resistors feeding the fb pin, to see if it changes the voltage, never worked with this chip.
 
Status
Not open for further replies.
Top