Hi,
I am making a power supply with DCDC converter.
The DCDC converter has an enable pin "EN" which need at least 2.4V (threshold) to turn on.
My controller is 1.8V.
How can i adapt these two voltage ?
And i would like that when there is no microcontroller connected, the EN pin is tied low (DCDC OFF).
Regards
I am making a power supply with DCDC converter.
The DCDC converter has an enable pin "EN" which need at least 2.4V (threshold) to turn on.
My controller is 1.8V.
How can i adapt these two voltage ?
And i would like that when there is no microcontroller connected, the EN pin is tied low (DCDC OFF).
Regards
Attachments
-
13 KB Views: 6