Hi guys, I just need a bit of help as I am a little stuck, probably an easy one.
So I currently have seven circuits in series so far which will be connected up in parallel:
2 X 3528 30CM 15 SMD Waterproof LED Soft Light Bar 12V LED Car Strip Light (sides) (0.1 amps)
2 X 3528 30CM 15 SMD Waterproof LED Soft Light Bar 12V LED Car Strip Light (base) (0.1amps)
2 X 12V 16.4ft LED Strip Light Flexible 27S (27 leds) (0.23A) / 28P (28 leds) (0.23A) - (3014)
1 X (6 X colour changing LEDs(2V), + 6 Blue (3.2V) (31.2V) (0.25amps))
(Will probably adding another strip of 16-20 3528 leds in series which will be added to the other circuits in paralell)
I have a 12V 2AMP adaptor plug, just wondering if someone can talk me through what resistors to put on each circuit?
Also I am worried about the last circuit too, works out at 31.2V, but they are the specs of the ultrabright LED's, I am hoping I can run them at 12V just fine?
Thanks again to you all, just haven't done a project this big before so just need a bit of a boost.
So I currently have seven circuits in series so far which will be connected up in parallel:
2 X 3528 30CM 15 SMD Waterproof LED Soft Light Bar 12V LED Car Strip Light (sides) (0.1 amps)
2 X 3528 30CM 15 SMD Waterproof LED Soft Light Bar 12V LED Car Strip Light (base) (0.1amps)
2 X 12V 16.4ft LED Strip Light Flexible 27S (27 leds) (0.23A) / 28P (28 leds) (0.23A) - (3014)
1 X (6 X colour changing LEDs(2V), + 6 Blue (3.2V) (31.2V) (0.25amps))
(Will probably adding another strip of 16-20 3528 leds in series which will be added to the other circuits in paralell)
I have a 12V 2AMP adaptor plug, just wondering if someone can talk me through what resistors to put on each circuit?
Also I am worried about the last circuit too, works out at 31.2V, but they are the specs of the ultrabright LED's, I am hoping I can run them at 12V just fine?
Thanks again to you all, just haven't done a project this big before so just need a bit of a boost.