Could use some help here with either improvements or alternate value suggestions or whatever to get this working properly...
I've got this schematic.
I press the switch 1 and the green LED should turn on and then latch the section on the right to have 48V present at RED1VCC..
Seems to work totally fine in simulation but not in breadboard..
I'm having 2 problems with this in breadboard..
1-When the power supply is turned on the LED is dimly glowing (about 10V is present at BAT1) .
2-The reset button is not resetting the circuit.
I'm fairly sure this is all from leakage current but I don't know enough to improve this to prevent that.
Help
I've got this schematic.
I press the switch 1 and the green LED should turn on and then latch the section on the right to have 48V present at RED1VCC..
Seems to work totally fine in simulation but not in breadboard..
I'm having 2 problems with this in breadboard..
1-When the power supply is turned on the LED is dimly glowing (about 10V is present at BAT1) .
2-The reset button is not resetting the circuit.
I'm fairly sure this is all from leakage current but I don't know enough to improve this to prevent that.
Help