Search all over and can't seem to find if there is a standard thread for table lamp holders with the threaded base.
I don't have one on hand as yet, but I found that there is a variation out there of either 10mm or 1/8th NPT.
I would have thought it fairly standard, at least on each continent!
Anyone with knowledge on the size?
I just need to look out the required drill and tap combo.
Max.
I don't have one on hand as yet, but I found that there is a variation out there of either 10mm or 1/8th NPT.
I would have thought it fairly standard, at least on each continent!
Anyone with knowledge on the size?
I just need to look out the required drill and tap combo.
Max.