All About Circuits

KiCAD PWR_FLAG Error

MaxHeadRoom

MaxHeadRoom

Joined Jul 18, 2013
26,690
Looks like you are using GND for two purposes, one for GND and one for - GND, you need a different -ve GND identifier flag.
Also J1 has a error flag which could mean that J1 has its pin labeled as Power-Out, if so you do not need a power flag for it.
 
chrihult

Thread Starter

chrihult

Joined Mar 29, 2022
2
MaxHeadRoom said:
Looks like you are using GND for two purposes, one for GND and one for - GND, you need a different -ve GND identifier flag.
Also J1 has a error flag which could mean that J1 has its pin labeled as Power-Out, if so you do not need a power flag for it.
Click to expand...
Thanks for your reply. I changed the pin labels on J1 to 'Passive' on all three pins, and the error disappeared!
 
You must log in or register to reply here.
Thread starter Similar threads Forum Replies Date
memedin KiCad PCB: enlarging areas General Electronics Chat 4
gok001 Polygon not connecting to pads(Kicad) PCB Layout , EDA & Simulations 3
sleigh.za My first ESP32 Dev board design PCB Layout , EDA & Simulations 4
spikespiegelbebop Convert .pcb file to kicad readable format? General Electronics Chat 16
S How to wrap a inductor around a resistor on PCB? PCB Layout , EDA & Simulations 26
Similar threads
KiCad PCB: enlarging areas
Polygon not connecting to pads(Kicad)
My first ESP32 Dev board design
Convert .pcb file to kicad readable format?
How to wrap a inductor around a resistor on PCB?

You May Also Like

Top