I have this meter and noticed that when on ohms, 20k, when no load is attached, the reading is not off limit like the other ranges are, it's near zero, wandering a bit, so it's reading near a short. And when I attach a resistor, the reading drops to practically zero, with hardly any wandering, so is some transistor or op amp not driving something ? I looked at the schematic, I went cross eyed with the switches.
When on volts, 20V works, so it's probably not the switch. I haven't checked the ampmeter yet, now I have a bench PSU so it should be easy, I forgot.
When on volts, 20V works, so it's probably not the switch. I haven't checked the ampmeter yet, now I have a bench PSU so it should be easy, I forgot.
Attachments
-
711.2 KB Views: 9