How to wind a ferrite cored transformer wihout bobbin?

Thread Starter

cmpx

Joined Oct 23, 2021
60
Can somebody show me the pictures or a video how to wind magnet wire onto E20 transformer ferrite core without plastic bobbin?
 

ronsimpson

Joined Oct 7, 2019
4,884
show me the pictures or a video how to wind magnet wire onto E20 transformer ferrite core without plastic bobbin?
It is next to impossible and not a good idea. I have winding machines that wind on bobbins. They will not wind directly on a core. The cores will scratch off the insulation. Cores will conduct at high voltage.
 
Wind the wire onto some block (from wood, plastic, whatever), probably 6x6mm. Then pull out the coil from this block carefully. Use enamel to fix the coil surface.
Then put the coil on core and fix with enamel.
 

MrChips

Joined Oct 2, 2009
35,299
Another idea is to wind the coil on any material on top of extended lengths of Kapton tape.
When you are finished winding the coil, remove the coil from the form and wrap the Kapton tape over the turns of the coil.
 

ZhangSheng

Joined Sep 25, 2026
17
Since your whole plan hinges on the insulating material — whether it becomes the bobbin substitute or the tape you wrap over the finished coil — it is worth choosing it by temperature class rather than by whatever happens to be on the bench.

PVC electrical tape vs. acetate cloth tape. Common PVC insulating tape is covered by UL 510, the UL standard for PVC/polyethylene/rubber insulating tape (it specifies flame retardance, dielectric strength, adhesion, and similar properties). Its continuous rating is typically around 80 °C, and the adhesive can cold-flow and creep under sustained tension and heat. That is fine for a wire splice in free air, but marginal as coil layer insulation that sits at transformer operating temperature for years. Acetate cloth tape (woven backing) is the traditional coil-shop choice for a reason: it is hand-tearable, conforms well to round bundles, has good tensile strength, and is generally used as a Class A (105 °C) insulation-system component — it ages far better than PVC at winding temperatures.

Polyimide tape (the kind MrChips suggested) sits in Class H territory (around 180 °C), is very thin, and has high dielectric strength — but it is not hand-tearable, its cut edges are sharp enough to nick magnet-wire enamel, and it is overkill for a low-voltage prototype.

On UL 94, since it shows up on tape datasheets: it is simply the standard test method for flammability of plastic materials. In the vertical burn test, V-0 means the specimen self-extinguishes quickly with no flaming drips; V-1 and V-2 are progressively less strict; HB is the horizontal-burn rating. It tells you about fire behavior only — not about dielectric strength or temperature rating, so do not confuse the two.

A few practical points for the no-bobbin method: ease the sharp ferrite core edges (they will cut through thin tape), wrap with a half-lap (about 50% overlap), keep tension moderate and uniform so the coil does not loosen when you pull the form out, and put a real insulated layer between primary and secondary instead of relying on the magnet-wire enamel alone. If this is for a switching supply, a single-turn copper-foil shield between the windings — insulated on both sides so it cannot form a shorted turn, and grounded at one point only — suppresses common-mode noise far better than any tape will.
 

Ian0

Joined Aug 7, 2020
13,312
Yes I agree thank you. Please what material should I use for creating one?
Fibreglass - have them made by one of the Chinese pcb companies. You can even put some lines of copper on them so you can solder them together (but be careful not to make a shorted turn)
 
Top