Hey All, Hope everyone is safe and healthy.
I am designing a very simple connection board where I would like to take two 17 pin ICs and run wires from it to another board. I would like to know how to add the connection points to my schematic in Kicad. I am new to this program and have googled it but haven't found anything. So I am imagining there will be 17 holes for each IC and they will be plated vias, is that correct? I would then run traces from the connection points to the pads for my ICs. Fairly simple. Just need Kicad information. Any takers?
I am designing a very simple connection board where I would like to take two 17 pin ICs and run wires from it to another board. I would like to know how to add the connection points to my schematic in Kicad. I am new to this program and have googled it but haven't found anything. So I am imagining there will be 17 holes for each IC and they will be plated vias, is that correct? I would then run traces from the connection points to the pads for my ICs. Fairly simple. Just need Kicad information. Any takers?