I have a Horizon T81 treadmill in excellent condition that I acquired in a non-running state. When I got it home, after checking all connections, it did initially work for a couple of minutes. I then transferred it into the house and it hasn’t worked since!! Everything looks good except that the belt motor does not run. Incline function is ok. No error codes when attempting normal operation.
Upper console lights up, I was able to access engineering mode and test seem to indicate everything ‘up top’ works ok. Auto speed calibrate does not drive motor. Gives E1 error I have tested the belt motor itself using a 12V battery and it works fine. There is no voltage output from the motor drive terminals on the board.
At the moment everything suggests to me a problem with the motor control board. I removed the control board, refreshed the solder connections on the board, checked diodes etc but haven’t found anything obvious so far. Did not change the symptoms. Without a schematic it is difficult to go further.
I’ve been looking for a replacement control board. Sites say that I need a 032671-HF whereas the one currently fitted is a SJED08092HF ver:H108 S106. They look to be physically identical as far as I can see from the photos but would like confirmation.
I understand that there may be someone who can repair these control boards. Could you advise me:
1. Is there anything else I should try?
2. Would you be willing to repair this board and, if so, at what cost, time?
3. Would anyone have a suitable replacement board for advance exchange?
Upper console lights up, I was able to access engineering mode and test seem to indicate everything ‘up top’ works ok. Auto speed calibrate does not drive motor. Gives E1 error I have tested the belt motor itself using a 12V battery and it works fine. There is no voltage output from the motor drive terminals on the board.
At the moment everything suggests to me a problem with the motor control board. I removed the control board, refreshed the solder connections on the board, checked diodes etc but haven’t found anything obvious so far. Did not change the symptoms. Without a schematic it is difficult to go further.
I’ve been looking for a replacement control board. Sites say that I need a 032671-HF whereas the one currently fitted is a SJED08092HF ver:H108 S106. They look to be physically identical as far as I can see from the photos but would like confirmation.
I understand that there may be someone who can repair these control boards. Could you advise me:
1. Is there anything else I should try?
2. Would you be willing to repair this board and, if so, at what cost, time?
3. Would anyone have a suitable replacement board for advance exchange?