Help identify SMD inductor #2
- Thread starter Purtto
- Start date
schmitt trigger
- Joined Jul 12, 2010
- 900
This is a house number. You have two options:
Read its value from the schematic.
Remove it and measure it with an LCR meter.
Read its value from the schematic.
Remove it and measure it with an LCR meter.
@Purtto; Welcome to AAC. Yes, it's a proprietary number. You won't likely find much information on line. Measuring it will be the best way to go. Why are you looking at it? It appears to be in good condition. Coils don't often go bad, so - - - .
Also, you should start your own thread with this question. By inserting YOUR question onto SOMEONE ELSE'S thread - you hijack it. Granted, the original poster may have long since gotten their answer and have left this tread, it's been close to three years since there's been a reply until you woke it up. But the right way is to start your own thread.
Also, you should start your own thread with this question. By inserting YOUR question onto SOMEONE ELSE'S thread - you hijack it. Granted, the original poster may have long since gotten their answer and have left this tread, it's been close to three years since there's been a reply until you woke it up. But the right way is to start your own thread.
6uH.
