Hello, not sure where to post this exactly for suggestions but here it is.
Problem, the cart motor mount is mounted to the cart as you can see in the pictures using two brackets with vertical slots on each bracket. The brackets are then bolted into the fram of the rear axle. The problem is the slots when adjusted to max distance apart. Start to slide down while the engine is running due to vibrations. This makes the chain loose some tension.
Does anyone have suggestions for re designing the mount? Or should I change what I am using? I need to be able to adjust the tension but I don’t want it to slip
I thought perhaps using a set of threaded rods would work but before I go out and try different things any thoughts?
Thank you!
Problem, the cart motor mount is mounted to the cart as you can see in the pictures using two brackets with vertical slots on each bracket. The brackets are then bolted into the fram of the rear axle. The problem is the slots when adjusted to max distance apart. Start to slide down while the engine is running due to vibrations. This makes the chain loose some tension.
Does anyone have suggestions for re designing the mount? Or should I change what I am using? I need to be able to adjust the tension but I don’t want it to slip
I thought perhaps using a set of threaded rods would work but before I go out and try different things any thoughts?
Thank you!
Attachments
-
187.8 KB Views: 12
-
242.2 KB Views: 12
-
210.4 KB Views: 11