I am trying to wire an external momentary switch to a garage door remote. I will then mount that new switch to the dash and the remote will sit behind the fairing.
I have two remotes to play with, but the larger one will not easily fit behind the fairing. However, I am able to figure out where to solder my leads. I can use a jumper cable and get the switch to activate.
On the smaller remote, where the switch posts come through the board, they are different. Almost as if there is a non-contact (probably not the right term) block between two solder points. Regardless of what I jumper, I cannot get the remote to activate. Any ideas??
I have two remotes to play with, but the larger one will not easily fit behind the fairing. However, I am able to figure out where to solder my leads. I can use a jumper cable and get the switch to activate.
On the smaller remote, where the switch posts come through the board, they are different. Almost as if there is a non-contact (probably not the right term) block between two solder points. Regardless of what I jumper, I cannot get the remote to activate. Any ideas??