Hello there, I am using a full bridge rectifier (as shown in picture) at the inverter output but my full bridge rectifier is behaving as a half bridge. I tried to test the diodes through multimeter, it seems to work fine.
Whenever I use the oscilloscope probes to check the voltage drop in the shunt resistor (to check my output current) it shows me only one side is getting rectified.
Please help, I am really getting stuck in here.
Best Regards,
Tahsina
Whenever I use the oscilloscope probes to check the voltage drop in the shunt resistor (to check my output current) it shows me only one side is getting rectified.
Please help, I am really getting stuck in here.
Best Regards,
Tahsina
Attachments
-
7.9 KB Views: 25