Hello,
I hopefully have made a small custom button shield for an arduino based device. I have used Kicad, and believe I have created a functional PCB, but I would like to make sure I am not missing any steps, havent made any blunders with the traces, and the gerber files are correct, as I am planning on ordering a fair amount of these, and want to make sure I am not making any obvious mistakes. I might add some more silkscreen text, but this should be complete, otherwise.
Attached is the project folder.
Thank you in advance for any advise, or information.
I hopefully have made a small custom button shield for an arduino based device. I have used Kicad, and believe I have created a functional PCB, but I would like to make sure I am not missing any steps, havent made any blunders with the traces, and the gerber files are correct, as I am planning on ordering a fair amount of these, and want to make sure I am not making any obvious mistakes. I might add some more silkscreen text, but this should be complete, otherwise.
Attached is the project folder.
Thank you in advance for any advise, or information.
Attachments
-
29.1 KB Views: 6
Last edited: