I have been leaning a technique to find short circuits on pcb boards using a can that freezes components , and then by adding low power to the board the heat unfreezes the bad components much faster , now I am still new and leaning about electronics and I have just got hold of a used variable power supply and I would like some help in how I hook this up to add power to a motherboard , I was thinking do I just use the negative wire from the power supply to negative on the board and then add the positive wire from power supply to positive to the motherboard ?
I would also like some help in working out the current and voltage setting to use to power the boards ?
I would also like some help in working out the current and voltage setting to use to power the boards ?