I have been trying to burn bootloader to an attiny85 board using arduino as ISP, and i have been getting this below error. Previously when i encountered with this error(previous projects) usually the TX would been communicating through serial monitor, so i couldn't upload the sketch, and would get the same above error. As a solution to that i would release the reset button as soon as i click the "upload sketch" and it worked!. But this time as was using an 10uf capacitor to stop arduino from resetting, there was no point in pressing the reset button. I also tried to upload a simple blink sketch before burning bootloader, so that the Tx remained off. But still the problem persists. I have never done this before and new to this.
arduino UNO, IDE version 2.0.3.
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x03
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x03
Failed chip erase: uploading error: exit status 1
arduino UNO, IDE version 2.0.3.
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x03
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x03
Failed chip erase: uploading error: exit status 1