Hi guy,

I have a problem simulating a EMG filter and amplifier with Multisim, each time it stuck around 0.505 sec. the simulation is uploaded to this topics.

 

Not everyone uses multisim. Upload a schematic.

What is your error message .... if any.

 

Hi JoeJester, I don't have any error it just get stuck the simulation a never continue after 0.505sec. Here is the schematic.

 

is there a definitive time for a transitional analysis?

Where is the Vcc and Vee? Where is the + and - 12VDC?

I don't see them anywhere on your drawing.

 

No

 

Where are the Vcc and Vee sources?

 

if you are using the interactive transient mode ... when is it set to stop?

You have number of circuits. Here are two EMG blurbs ... https://www.intechopen.com/books/co...-design-considerations-for-robotic-prosthesis

and

https://prostheticoss.wordpress.com/tag/emg/

 

It seems to me you have way too many circuits. Can you produce a block diagram of what your trying to do?