Hi All
I am aiming to use the following connector from Samtec
MEC1 - 1.00 mm Mini Edge Card Socket, Vertical | Samtec
This is the first edge type of connector i am using.
The actual connector footprint can be downloaded.
But is there any footprint for the actual edge pads and the point where the polarity cut needs to be made? Or is this something that needs to be drawn from stretch?
I am aiming to use the following connector from Samtec
MEC1 - 1.00 mm Mini Edge Card Socket, Vertical | Samtec
This is the first edge type of connector i am using.
The actual connector footprint can be downloaded.
But is there any footprint for the actual edge pads and the point where the polarity cut needs to be made? Or is this something that needs to be drawn from stretch?