Hi
I'm trying to create an Eagle part in my own lib of an MM232R USB/UART where pins 1 AND 16 are both SHIELD but can't figure out how to do this.
If you were to look at the Atmega MEGA8P (Atmel.lbr) for example, in the .sch, pins 8 and 22 are both named GND and then when you switch to .brd, there's an air wire all nice and in place between these two pins. That's what I'd like to do with the SHIELDS in my effort.
I looked at the symbol of the MEGA8P (DIL28-3) in the Atmel.lib and see that the term GND@1 is used for pin 8 but when I tried similar - no joy. I also can't see anything in the package or device editors that show how this is done.
Anyone know how to do this?
Many thanks.
I'm trying to create an Eagle part in my own lib of an MM232R USB/UART where pins 1 AND 16 are both SHIELD but can't figure out how to do this.
If you were to look at the Atmega MEGA8P (Atmel.lbr) for example, in the .sch, pins 8 and 22 are both named GND and then when you switch to .brd, there's an air wire all nice and in place between these two pins. That's what I'd like to do with the SHIELDS in my effort.
I looked at the symbol of the MEGA8P (DIL28-3) in the Atmel.lib and see that the term GND@1 is used for pin 8 but when I tried similar - no joy. I also can't see anything in the package or device editors that show how this is done.
Anyone know how to do this?
Many thanks.