Facebook
Google
GitHub
Linkedin
I used the idea from this post on the tricks and tips Thread 2025. @Jon Chandler
https://forum.allaboutcircuits.com/threads/electronic-tricks-and-tips-y2025.204710/#post-1967021
The bottom is one inch high, which will cover most shanks on Dremel tools. I had to keep re-printing the top to allow for the odd sizes that were taller than others. The corrugated plastic is easily available from Amazon, I cut it into one-inch strips and then fitted it into the bottom piece.
https://forum.allaboutcircuits.com/threads/electronic-tricks-and-tips-y2025.204710/#post-1967021
The bottom is one inch high, which will cover most shanks on Dremel tools. I had to keep re-printing the top to allow for the odd sizes that were taller than others. The corrugated plastic is easily available from Amazon, I cut it into one-inch strips and then fitted it into the bottom piece.
Last edited:
