hi...

I have 3 resistance from Monitor inverter board and they have the 1504 sign on them.

If i watch the pdf of the monitor they should be 3M,3M and 2M7

Is that because of the different revision of the board (and 1504 is really 1.5M) or there is other explanation?

Thanks in advance

 

1.5MΩ

 

What wattage should i pick?

In the power scheme i see only the value of resistance

 

Yes 1.5M,
The wattage is determined by the current /voltage in the resistor, what part of the circuit are they in, a diagram would help?

 

https://drive.google.com/file/d/0Bxome1ZSCRIaNmFOdmMxMWM2eG8/view?usp=sharing

We watch IC802 and it`s 5 pin. The Resistances are 833,834,835.

These i desoldered were marked all of them 1504.

 

the diagram shows four 3M resistors in series that's approx 12Meg, if you have the circuit what's the problem?

 

One of the conditions in the block-scheme for not working monitor was checking of voltage X and if it was not that value was written to check R833 834 835. I may destroid two of these three and now have to buy 3 x 1504 and put them back