Design Tasks

Thread Starter

artmaster547

Joined Jan 6, 2016
409
I wish to create the following:

a sinewave generator with the following properties, but it must use a 3 stage RC phase shift oscillator as a base:
  1. power supply is nominally +9 V, but could be ±3 V, relative to a ‘ground reference’ of 0 V.

    2.output is a sine wave of frequency 1 kHz (ideally free of any harmonic content) and varies between a minimum value of +1 V and maximum value of +3 V, into an unknown resistive load as low as 1kOhm.
I have created the basic phase shift oscillator it's meeting the other requirements in part 2 that I am struggling with any help would be appreciated
 

Thread Starter

artmaster547

Joined Jan 6, 2016
409
no not homework this is for a individual project I'm carry out as a response to theory I'm being though because I understand the basic principle but struggling to understand how to adjust parameters or add to the basic topology to meet these other criteria
 

Attachments

Top