I am looking to replace the commutator on the dc motor I have built with some sort of motor controller. The motor is 12v battery into a 220v 100w inverter through a bridge rectifier, choke, 450v 470uf cap. Using 2 neo magnets glued to a 4mm shaft and an electromagnet which is pulsed north to north. All very new to me...
http://www.youtube.com/watch?v=NtKMWjG60B4&feature=PlayList&p=E7200EF7020D58EC&index=86
The motor is similar to this one on you tube (pulse motor).
The magnets on my motor are glued on the shaft north-south which makes
timing it a bit of a challenge. He has a controller instead of a commutator I
would like to do the same which wont fry when I put up to 400v through it.
http://www.youtube.com/watch?v=NtKMWjG60B4&feature=PlayList&p=E7200EF7020D58EC&index=86
The motor is similar to this one on you tube (pulse motor).
The magnets on my motor are glued on the shaft north-south which makes
timing it a bit of a challenge. He has a controller instead of a commutator I
would like to do the same which wont fry when I put up to 400v through it.
Last edited: