Hi,
I am using a Brushed DC motor for one of my project and in order to use break condition I put the two MOSFET on the Full bridge HIGH.
it is similar to connecting the positive and negative wire of the motor .
When I do this , I find hard to turn the shaft. Can I please know internally what's happening in the motor?
I am using a Brushed DC motor for one of my project and in order to use break condition I put the two MOSFET on the Full bridge HIGH.
it is similar to connecting the positive and negative wire of the motor .
When I do this , I find hard to turn the shaft. Can I please know internally what's happening in the motor?