Hello everybody,
I am installing a conventional fire alarm system in a building (UniPOS FS4000 series). I have been provided with CQR manual call points FP3/RD, the manual of installation is attached.
I am trying to connect this manual call point using CR1 2x0.9 cable, the problem is i tried all the possibilities, but it does not seem to work, anyone has clue why ?
I am installing a conventional fire alarm system in a building (UniPOS FS4000 series). I have been provided with CQR manual call points FP3/RD, the manual of installation is attached.
I am trying to connect this manual call point using CR1 2x0.9 cable, the problem is i tried all the possibilities, but it does not seem to work, anyone has clue why ?
Attachments
-
794.7 KB Views: 4
Last edited: