connect RF remote control 4 channel to atmega

Discussion in 'Wireless & RF Design' started by Nasi Mahi, Aug 16, 2016.

  1. Nasi Mahi

    Thread Starter New Member

    Aug 6, 2016
    I want to connect this module photo_2016-08-16_18-38-58.jpg to atmega and turn on/off led ,I start from where? Is there any simple example exist??
  2. tracecom

    AAC Fanatic!

    Apr 16, 2010
    Sure. Each of the four buttons on the remote will cause one of the four outputs on the receiver to go high. The transmitter runs on a 12v battery, but the receiver will do fine on 5v.

    And uncurl that antenna.
    Last edited: Aug 25, 2016