Attempting a repair of a blender (Cuisinart CPB-300C) which lights up but the motor will not start. The usual suspects like motor and thermal fuse are ok and other elements on the board I could check seem fine (as far as what can be tested with a multimeter).
Three are the buttons one that switches from pulse to steady run and the other two are one for slow and the other for fast, so not much to it.
There is only one IC which I cannot find the datasheet for, it reads TG66593A but googling for it led to nothing.
(I know a simple switch with diode for off/low/high can do the job but I would prefer to try to recuperate the board before cutting into the blender case to install it)
Three are the buttons one that switches from pulse to steady run and the other two are one for slow and the other for fast, so not much to it.
There is only one IC which I cannot find the datasheet for, it reads TG66593A but googling for it led to nothing.
(I know a simple switch with diode for off/low/high can do the job but I would prefer to try to recuperate the board before cutting into the blender case to install it)