Hello,
I am asking a question, about using an isolation transformer.
I have a DC motor (100 volt) from my micro milldrill machine, I am tired of replacing the PWM controle board, I seen a block diagram of how this board works, and from the diagram, the mains is connected to the H-bridge rectifier, and filtered and then sent to the motor,
I have a thoro understanding of the diagram, I don't want to use the comercial way of doing it by hooking the rectifier directly to the mains.
I am going to build my own PWM circuit for it, however,
Here is my question, Is it safe and can I use a 1:1 isolation transformer to isolate the main power, and use the 120v.off of the secondary to rectifiy and bring power to the motor / circuit.
I have built numerous power supplies from scratch, using step down power transformers, for low voltage applications, so I am proficient in designing power supplies, I just never built a supply larger than 30v., and was wondering if using the 1:1 isolation power transformer would be safe.
If not I will either try to run the motor at a lower voltage, or purchase a lower voltage motor, to build a linear supply for,
Thanks for any help.
I am asking a question, about using an isolation transformer.
I have a DC motor (100 volt) from my micro milldrill machine, I am tired of replacing the PWM controle board, I seen a block diagram of how this board works, and from the diagram, the mains is connected to the H-bridge rectifier, and filtered and then sent to the motor,
I have a thoro understanding of the diagram, I don't want to use the comercial way of doing it by hooking the rectifier directly to the mains.
I am going to build my own PWM circuit for it, however,
Here is my question, Is it safe and can I use a 1:1 isolation transformer to isolate the main power, and use the 120v.off of the secondary to rectifiy and bring power to the motor / circuit.
I have built numerous power supplies from scratch, using step down power transformers, for low voltage applications, so I am proficient in designing power supplies, I just never built a supply larger than 30v., and was wondering if using the 1:1 isolation power transformer would be safe.
If not I will either try to run the motor at a lower voltage, or purchase a lower voltage motor, to build a linear supply for,
Thanks for any help.
Last edited:
