Hi,
I have a SSR (Solid State Relay). The mark code is: DPA4111 which is burnt. I attach its picture and its respective datasheet.
Datasheet: http://www.crydom.com/en/products/catalog/dpa-series-ac-pcb-mount.pdf
The SSR is connected to the following ICs:
4116R-1 Network Resistor
74HC374: Octal 3−State Non−Inverting D Flip−Flop
So I assume it's controlled using 5V.
Can I replace it with a jq1a-5V electrically speaking? Picture attached.
I know that pinouts are not the same. But if I can replace it, I can adapt the pinouts.
Also, I should add a freewheeling diode, I think.
I have a SSR (Solid State Relay). The mark code is: DPA4111 which is burnt. I attach its picture and its respective datasheet.
Datasheet: http://www.crydom.com/en/products/catalog/dpa-series-ac-pcb-mount.pdf
The SSR is connected to the following ICs:
4116R-1 Network Resistor
74HC374: Octal 3−State Non−Inverting D Flip−Flop
So I assume it's controlled using 5V.
Can I replace it with a jq1a-5V electrically speaking? Picture attached.
I know that pinouts are not the same. But if I can replace it, I can adapt the pinouts.
Also, I should add a freewheeling diode, I think.
Attachments
-
6.5 KB Views: 2
-
6.4 KB Views: 4