I believed the burned part was HCB1608KF-121T30 but it was not.Bought a 1000 of them and they were waaaay to small. What do you think I need to replace. The computer boots and an extreme heat signature shows in the obvious location.

I believe I printed the part of the schematic relevant to this part of the computer.
Thank you.

 

Here is a picture of me holding a HCB1608KF-121T30 next to the damaged area. The burned component seems to be much bigger.

 

Can this be fixed? Is there a high risk of there being greater damage than just the burned (I assume) ferrite bead?