hi buddies i am now on the process of building a toy truck of 500x450 mm ... the speciality of this is .. the truck is not powered by batteries for running ... it is made to be driven by a smaller engine of 3.5cc with a small fuel tank. the mechanical setups are almost finished...
now i have to automate the truck with remote control ... the remote should be capable of controlling the 1.forward & backward movement 2.turning right and left 3. applying break ... the restriction is that i hav to use only 12v so please suggest me guidelines...... ie what kind of transmission and recieving circuit i have to use what ... what frequency is suitable ... any any other ideas relating this

 

Hello,

For remote control there is a special forum at RCGroups.
http://www.rcgroups.com/forums/index.php
They are specialized in remote control.

Greetings,
Bertus

 

Unless you have to build the electronics, it would be best to buy a RC remote control system.

 

E-bay vendors offer several types of pre-made RC kits which would fill the bill.

 

Hi,
You could buy one or make a remote control circuit with HT12E and HT12D.
Thanks.

 

Hi,i think u can use infrared transmitter and its receiverIt uses infrared radiations.Currently i have no cct but immediately i get it i'll post.Thanks

 

Hi,i think u can use infrared transmitter and its receiverIt uses infrared radiations.Currently i have no cct but immediately i get it i'll post.Thanks

Hi,
Miringu, HT12E and HT12D by Holtek, are infrared transmitter-receiver ics, able to control upto 4 channels, based on 38kHz modulated infra-red signal. Ofcourse an oscillator has to be built and interfaced with the HT12E, which is the transmitter. Signal is transmitted via the IR LED from the output of the transmitter. HT12D received the signal via IR sensor, such as TSOP1738, by Vishay. The signal is demodulated and 4 channels can be driven. It is very easy circuit and a novice can make it. I made it before, and if required, I can post the schematic.

Thanks.

 

Hi,
Miringu, HT12E and HT12D by Holtek, are infrared transmitter-receiver ics, able to control upto 4 channels, based on 38kHz modulated infra-red signal. Ofcourse an oscillator has to be built and interfaced with the HT12E, which is the transmitter. Signal is transmitted via the IR LED from the output of the transmitter. HT12D received the signal via IR sensor, such as TSOP1738, by Vishay. The signal is demodulated and 4 channels can be driven. It is very easy circuit and a novice can make it. I made it before, and if required, I can post the schematic.

Thanks.

Exactly thats what i meant,only that i didn't go into details

 

Since the truck is quite large and powered by a small engine, I would imagine that it is intended for use outside which limits the reliability of an infrared system and you wouldn't want to lose control of a vehicle this size. Also, a simple on/off control such as that provided by an HT12 system is unlikely to give very precise speed and steering control.