Hello everyone (forgive my very average english),
I did a PCB mount of a VCO that outputs a variable frequency of around 10MHz, so far so good.
However, when I put a simple wire for the output I get a pretty clean signal like this:
Whereas when I put a BNC output with a BNC cable I rather get this:
What to do to remedy the problem, because I would like to have a BNC output? I have heard of impedance matching but where do I start?
thank you
I did a PCB mount of a VCO that outputs a variable frequency of around 10MHz, so far so good.
However, when I put a simple wire for the output I get a pretty clean signal like this:
Whereas when I put a BNC output with a BNC cable I rather get this:
What to do to remedy the problem, because I would like to have a BNC output? I have heard of impedance matching but where do I start?
thank you