My a/c blower fan resistor in my truck fails and causes the fan to work only on high. Apparently it’s just a poor design with the resistor being to close to the heat sink coils. The dealer recommends spreading the coils apart to allow for better heat dissipation. This doesn’t always seem to work as other vehicle owners stated.
I was thinking about cutting a 1’’ piece of heat resistant wire loom material and placing it between the resistor and coil to shield it from heat.
Any thoughts or ideas would be appreciated.
I was thinking about cutting a 1’’ piece of heat resistant wire loom material and placing it between the resistor and coil to shield it from heat.
Any thoughts or ideas would be appreciated.
Attachments
-
68.2 KB Views: 23
-
198.2 KB Views: 23
-
177.3 KB Views: 23
-
216 KB Views: 19
-
756.9 KB Views: 20