Good afternoon,
Long time, no see. So I have a question about epoxies for repairing modern PCB boards. I get the odd board with heat damage to the point where I have to scrape down to get the carbon damage out of it. What is left is maybe a deep pit or sometimes right through the board so I want to know what is the best epoxy for this type of repair. I have tried a few but found that they remain soft or hard to fasten tracks to. Which leads to the next question. What is the best method for fasting existing or hand-made traces back to the board once the epoxy is set. I know there are elaborate kits out there for way too much money. Hoping someone has a tried and true method that doesn't cost a gazillion dollars. Thankyou in advance.
Lots of new names/faces on here since I was here last. Good to see.
Long time, no see. So I have a question about epoxies for repairing modern PCB boards. I get the odd board with heat damage to the point where I have to scrape down to get the carbon damage out of it. What is left is maybe a deep pit or sometimes right through the board so I want to know what is the best epoxy for this type of repair. I have tried a few but found that they remain soft or hard to fasten tracks to. Which leads to the next question. What is the best method for fasting existing or hand-made traces back to the board once the epoxy is set. I know there are elaborate kits out there for way too much money. Hoping someone has a tried and true method that doesn't cost a gazillion dollars. Thankyou in advance.
Lots of new names/faces on here since I was here last. Good to see.