Hey all,
I have a 3 phase advance lift table that I am using (manually) to load plywood onto a CNC router. It is a hand remote with 2 switches. Up and down and a disconnect...(see attached diagram).
What I am trying to figure out is, I would like to build a control box with a Hand Off Auto switch where hand works as it does currently, and auto would affect up only. In auto Either an eye or mechanical switch would open/close after the top sheet of plywood was removed it would then wait 20-30 seconds and raise the table up 3/4", retripping the switch and stopping with the next sheet in position. Is this possible? Probably wouldnt hurt if an estop was added as well. Thanks in advance for your help!!
I have a 3 phase advance lift table that I am using (manually) to load plywood onto a CNC router. It is a hand remote with 2 switches. Up and down and a disconnect...(see attached diagram).
What I am trying to figure out is, I would like to build a control box with a Hand Off Auto switch where hand works as it does currently, and auto would affect up only. In auto Either an eye or mechanical switch would open/close after the top sheet of plywood was removed it would then wait 20-30 seconds and raise the table up 3/4", retripping the switch and stopping with the next sheet in position. Is this possible? Probably wouldnt hurt if an estop was added as well. Thanks in advance for your help!!
Attachments
-
199.8 KB Views: 9