I purchased a MP3 player card to connect to the arduino uno
Seen here:
http://www.mdfly.com/products/sd-card-mp3-player-module-rs232-ttl.html
I have it hooked to the arduino as follows
MP3 PIN 15 (RXD) to Arduino TX
MP3 PIN 19 (GND) to Arduino Analog GND
MP3 PIN 20 (VDD) to Arduino 5v
I have a pair of "old school" computer speakers with external power supply. I have not stripped any wires. It's stated I need 3 caps to between the arduino pins and mp3 module pins. Do I use a breadboard to get this part working or can I use the jumper wires I currently have?
I'm so close, any help is appreciated.
Thanks.
Seen here:
http://www.mdfly.com/products/sd-card-mp3-player-module-rs232-ttl.html
I have it hooked to the arduino as follows
MP3 PIN 15 (RXD) to Arduino TX
MP3 PIN 19 (GND) to Arduino Analog GND
MP3 PIN 20 (VDD) to Arduino 5v
I have a pair of "old school" computer speakers with external power supply. I have not stripped any wires. It's stated I need 3 caps to between the arduino pins and mp3 module pins. Do I use a breadboard to get this part working or can I use the jumper wires I currently have?
I'm so close, any help is appreciated.
Thanks.