Hi guys
Not sure if you guys came across this before, the PIC24FJ128GA610 stop working when over a certain voltage level.
I have tested two different:
Both chip tested on my own PCB, I actually by pass my voltage regular when I tested it. Both chip version is A3. All the VCC and GND got a 1n and 100n by pass cap. and 10uF on the Vcore where is required.
Any thought?
Not sure if you guys came across this before, the PIC24FJ128GA610 stop working when over a certain voltage level.
I have tested two different:
- Chip 1 - stop working when VCC >= 3.25V, start working again if I lower the voltage
- Chip 2 - stop working when VCC >= 3.40V, start working again if I lower the voltage
Both chip tested on my own PCB, I actually by pass my voltage regular when I tested it. Both chip version is A3. All the VCC and GND got a 1n and 100n by pass cap. and 10uF on the Vcore where is required.
Any thought?