How different ?? Q = B1Since B0 is always 1, then you can remove every other row in your state table. Why have it in there if it is not needed. You should state that B0 is always 1 before the table so the professor will know why it is not included in the table.
Ok, i remove it.(see attached fig 3)
Since Q = B1, whenever Q is different from B1 as in the 7th, 8th, 15th, and 16th state, what will happen? What should you say on the table?
it is toggling commandWhat I am saying is that since Q (an output) sets B1 (an input) to the same level, how can you have B1 as 0 when Q is forced to 1 since J is 1 ? What happens then ?
yes , because B1 = Q and B0=1OK, now that we established that the output Q toggles, that is then written in the state table. Does the toggling effect any other outputs (A>B, A=B) ?
ok ,i.e. my solution (fig3) is correctJust saying that the output toggles would be good enough.
Thread starter | Similar threads | Forum | Replies | Date |
---|---|---|---|---|
Help me analyze this EQ circuit | Analog & Mixed-Signal Design | 22 | ||
How to analyze complex electronic circuit ? | General Electronics Chat | 15 | ||
P | could you tell me how to analyze this circuit? | Homework Help | 12 | |
A | Help to analyze a circuit | General Electronics Chat | 4 | |
L | Analyze this Sequential Circuit | Homework Help | 12 |
by Aaron Carman
by Jake Hertz
by Duane Benson
by Aaron Carman